so far it is just a wet cell design of my own but am building Hydrogen Garage's 13 plate wet cell.

by Gary Foutch
(Oklahoma City Area Oklahoma USA)

hydrogen booster dry cell and wet cell both good.. I use Hydrogen Garage's 13 plate wet cell with shrink tubing to seal edges of the plates. Andrew says he has run this design on his own car for many yrs and it needs little attention..;.just some resealing of edges over time.. and it gets great mpg with a tall square wave PWM and EFIE..
My design dry cell...is in development phases.. need to get reproducable and quick assembly way to seal edges in wet cell design. I have been working on this but have not gone commercial yet..
may not ?? I believe it is possible to do this without infringing on HG.. or any known products including Bob Boyce designs.. if we keep our noses tight against the net web sites of unique and quality designs.. so many on line it is hard to tell all the good from the bad.. a few canning jar designs still out there... I do believe Ozzie Freedom started out with some good associates... check out an old article on line : Water4Gas Interactive Troubleshooter. some good info there. Also ck out any Patric Kelly pdf from PESwiki. I am months if not years behind due to life challenges that seemed to interrupt my progress in this endeavor but am dedicated to doing my research in this area..
say NO to NaySayers !!! Viva Over Unity and Keep your amperes up. Okie Gary