questions/suggestions

by Jim
(Pensacola,FL)

I am early in the process myself on whether to build a Pulse Width Modulator for an HHO cell or to build one. But if I could guess from your video about the results you obtained from your demonstration of your PWM HHO cell experiment; I'd say that the farther apart you put the electrodes the more current you will need to generate HHO gas,as the usual plate spacing seems to be 1/16th of an inch. And also if your LED's are blinking at the same pulse rate as your output to the HHO cell, then I'm guessing the pulse rate was too slow. From other circuit designs, I'm seeing a starting pulse rate usually beginning at 100Hz and adjusting up to 400Hz and some even higher. So my question is; what is the pulse rate range of your design?
Thanks for sharing your site!

---------------------------------------------
Thanks for the comment, Jim.

I'm not sure what the pulse rate range is because I don't have an oscilloscope to measure the pulse.

I've been so involved with my job that I haven't devoted the time I desired to provide a more informative making hydrogen website.

Thanks again,

Jeff